Aspire Atlantis 2 Question/Problem

[evanreynolds1116]

So I just picked up the Atlantis 2 today and I have a few questions/concerns.

First off:

What is a good wattage range for the .3 ohm coils ? Im guessing somewhere between 40-70w

Does it have a weird brake in period ? Because it's not producing very much vapor at all...

I put a 3mg juice in the tank and it's hitting like a 8mg or 10mg which is weird.

Anyone else having problems with it ? I'm using it on a 150w Sigelei

 

[dbrandt01]

Never used the Atlantis 2, but I have the first version. Did you wash it?
I could see maybe machine oil could make it seem harsher. Did you prime the coil before putting it in the tank? I make sure the cotton is perfectly saturated before even putting a new coil into the tank.

 

[evanreynolds1116]

Never used the Atlantis 2, but I have the first version. Did you wash it?
I could see maybe machine oil could make it seem harsher. Did you prime the coil before putting it in the tank? I make sure the cotton is perfectly saturated before even putting a new coil into the tank.

Before I used it I washed it out for 5 minutes, cleaned it out, saturated the juice holes and the coil itself, let it sit in the tank for 15 minutes, and then took hits without pressing the fire button, and then used it starting off at 40w and it was that bad. Just put a different 3mg juice in it and it's normal.

Seems like they labeled it wrong and that's dangerous.

 

[dbrandt01]

Sounds good, I apologize if I was asking simple questions, but I've seen it before on here and it was the problem. That's pretty bad on the company if the juice was labeled wrong. It's going to cause someone to probably get sick at some point. Glad you got it sorted out.

 

[WharfRat1976]

Start out at very low wattage during break in period. Yes, not much vapor will be produced. Slowly ramp up wattage. Max it out at 30. I vape my A2 usually below 30 with rebuilds or stock coils.