I would like to see the tank press-fit onto the base rather than screw on
I've always had great luck with my old Spheroid and love it dearly but I am not doing something right with my Heron. I do know that it is capable of being magnificent. For a short period everything was working perfect but something went wrong and for the life of me I just can't get it right.
Is there someone that can coach me on this thing? By PM would be fine so that way we don't take up a lot of thread. Just a quick rundown: 17 x 65mm with v2 fluff, S'nC yarn wick up through the topper with tails on the bottom, 1.0 ohms micro coil with 28g Kanthal, mounted on my stainless v3 with an 18650 AW, v1.0 and all three holes open. The juice is 50/50. I get juice below the base on the contact and dry hits without chain vaping.
The Heron requires A little more adjusting to find your sweet spot with the topper.I've always had great luck with my old Spheroid and love it dearly but I am not doing something right with my Heron. I do know that it is capable of being magnificent. For a short period everything was working perfect but something went wrong and for the life of me I just can't get it right.
Is there someone that can coach me on this thing? By PM would be fine so that way we don't take up a lot of thread. Just a quick rundown: 17 x 65mm with v2 fluff, S'nC yarn wick up through the topper with tails on the bottom, 1.0 ohms micro coil with 28g Kanthal, mounted on my stainless v3 with an 18650 AW, v1.0 and all three holes open. The juice is 50/50. I get juice below the base on the contact and dry hits without chain vaping.
The Heron requires A little more adjusting to find your sweet spot with the topper.
When I use cotton, true cotton, I use a topper. Getting the length of the cotton will take a tad of practice. I tend to leave one end down to help mop up whatever gets to the deck. The other end usually ends up at about 1/4” above the topper. But here is the thing. Unless there is sufficient cotton at that top area it will want to fall in. So leave it as wide as you can while experimenting.
As for SnC, I don’t usually use the topper. I treat it more like a spheroid. Either both ends up or one up and one down again to mop up some juice.
There will be a few trial runs before you find the spot.
Sometimes you just don’t want to be normal
OMGSG, AFC!!!Sneak Preview: GP Spheroid v4 prototype side to side with GP Spheroid v3, both on GP Piccolo v4.
Oh good question!!!!Will the AFC for the Spheroid be available separately? Looks lovely!