Problem with Aspire Mini airflow

[Shae McAualy]

Hey guys/girls, hopefully this is the right section, if not can a mod please move it.

Alright so I have 2 Aspire minis, both have recently had their coils changed and are only finger tight. But one of my tanks has developed a much tighter draw, to the point that there is barely any vapor coming out.

I have both the tanks on the same airflow setting (3rd highest), but there is a huge difference in the draw. I have cleaned both of them out, just with running water, but I imagine there could be some sort of gunking problem?

Any ideas?

 

[Jdurand]

First you have to take it completely apart to determine where the restriction is. I would assume it must be in the base section, otherwise it would probably be pretty obvious. Try blowing some air through the air hole to see if it seems blocked. You could try a good soak in some kind of alcohol as well. Are you sure it's not just a faulty coil? try to just swap the coils from tank to tank, or just a new coil. Good luck.

 

[DreamWithin]

Moved from carto tank forum to Clearomizers

 

[erikbal]

Could be the coil itself. Like stated above just swap the coils and see if its the coil itself.

Sent from my VS980 4G using Tapatalk

 

[Panorama911]

Yep....sometimes the coils have more restriction to them. Try this...the bottom center pin has a hole in it, spin it 180 degrees.