Lots of little details that are tedious and time consuming, little things that make the difference between a aluminum bar with holes drilled in it and the finished product, holes ate all perfectly finish and shaped, tops are perfectly mated with the bottoms etc. They ate going to come out awesome! They will take a little longer bc I have to yield to the sx mods, I work on the sx mods first and foremost so in can get them finished as soon add possible.wow man it looks like a ton of tedious work! but man the end result is awesome.
Lots of little details that are tedious and time consuming, little things that make the difference between a aluminum bar with holes drilled in it and the finished product, holes ate all perfectly finish and shaped, tops are perfectly mated with the bottoms etc. They ate going to come out awesome! They will take a little longer bc I have to yield to the sx mods, I work on the sx mods first and foremost so in can get them finished as soon add possible.
Yeah I can do that too! Anything for you momma!
Someday I'll actually get to vape with a TMod. One is at Dready's, two are in the stack of aluminum, above, and the last is the SX350J. Prolly they'll all show up at once! Anticipation ...
Slick!Hahah I hear that!
Bling bling.
By far the best I've seen..... I love gold though.... I thought you used a gold that was darker before... Is that a new gold color? That looks like it should be stored @ fort Knox!Hahah I hear that!
Bling bling.
Then do what. Subtract the ohms from 4v?Just measure the battery with a multimeter out of the mod first then stick the prods on the pos and neg screws on your atty and fire. Just remember to wipe the juice off the prods after you're done.
Hmmmm I really like that look! Kinda understated but really cool at the same timeLizzard UNDER blasted
I DGOLDED all my contact points on my TMod. I love the throw. It's getting softer. My bottles have been leak free. Y'all are NUTZ.
Then do what. Subtract the ohms from 4v?
Yes, that step was omitted in the OP. Thanks!I found if I over-tightened the bottles they would leak, ~1/8- 1/4 turn past snug and I'm good.
Subtract Voltage measured across the positive & Negative posts of the atty (voltage with load) from the Voltage measured at the 510, no atty (voltage unloaded/ no device connected), this is your voltage drop under load.
What is dgolded?I DGOLDED all my contact points on my TMod. I love the throw. It's getting softer. My bottles have been leak free. Y'all are NUTZ.
ok. what does that do? where do you put it on the tmod? how does it help?Deoxit Gold