Coil help
- Thread starter Outcast
- Start date
- th_trl_thread_readers 0
- Status
You could try posting in the APV area.
APV Discussion | E-Cigarette Forum
I'll take a guess:
Your ohms may be too low for your device. Check the specs.
Just a guess tho.
APV Discussion | E-Cigarette Forum
I'll take a guess:
Your ohms may be too low for your device. Check the specs.
Just a guess tho.
I'm still kinda new at this I made a .24 ohms 6 wraps my mod only is 60watts but it's only pushing 3.80 volts did I do something wrong
Sent from my iPhone using Tapatalk
What is the question?
Sounds like you are asking why the mod is outputting 3.8 volts.
3.8 x 3.8 / 0.24 = 60.16
ya; that's right; at 60 watts you mod will put out 3.8 volts.
Ya I was thinking it shod be +4.1 as a rule 3.6 as a min our is that only mech mods
Sent from my iPhone using Tapatalk
what mod is it? you should check steam engine to find out what the ohm sweetspot is for that mod.
I bet it's 0.6 ohms
I bet it's 0.6 ohms
May need to get some different wire I only have 24ga and 26ga takes like 18wraps to get to .9 running duel coils
Sent from my iPhone using Tapatalk
Coil wrapping | Steam Engine | free vaping calculators
10 wrap on 4mm 26 gauge dual coil 0.9 ohm
or try this
Coil wrapping | Steam Engine | free vaping calculators
7/8 wrap on 4mm 26 gauge 0.7ohm puts flux closer to 200 at 60 watts
Coil wrapping | Steam Engine | free vaping calculators
8/9 wrap
0.7 ohm
60 watts
26 gauge
3.5 mm ID
190 mW/mm2
My just did that wrap much better vape got .68 prob going to get some 28ga to get to .9 better
Sent from my iPhone using Tapatalk
3.8 volts is right where you should be for a 0.24 ohm build on a regulated mod set to 60 watts.
- Status
