question: when doing the update to 1.092 firmware with the new software how long did it take to complete the download of the file and do the update. mine seems to take a very long time.
I know the anxiety that can be experienced in waiting, I know it myself, and enjoy that feeling.
You'll enjoy this thing even more. Used it all day yesterday and no problems just fun, hell, even the wife said hey put that color on green.
R 48
G 226
B 35
Now the chances of me leaving the light on are very slim, but it's fun right now, so go with it.
question: when doing the update to 1.092 firmware with the new software how long did it take to complete the download of the file and do the update. mine seems to take a very long time.
question: when doing the update to 1.092 firmware with the new software how long did it take to complete the download of the file and do the update. mine seems to take a very long time.
i filled mine half way, as it set overnight, it all leaked out the bottom, i think the seal at the bottom of the coil is the cause of the leaking.
just some vgWhat PG/VG ratio is your juice in the tank?
Sent from my XT1032 using Tapatalk
Did you damage your Seal?
Coil head must be tight
Tank 1/2s most be good and tight.
No leaks here.......................so far
Did you over heat the coil?
Did you close the air holes when filling?
Did you fill the tank in the correct slot and not the hole in the middle?
There are very specific instructions on how to fill the tank to prevent leaking. I have read some leaking issues but I believe they were resolved by properly filling the tank.
If you filled the tank down the chimney (round hole in middle) the juice will leak out of the air holes in the bottom of the coil.
no i did not fill down the middle....LOL
Not afraid to admit I did when my package arrived. I wasn't paying attention watching football and filling the tank, next thing I know juice is all over the place.
Quite embarrassing considering I've owned a TFV4 since July.
ok i did get the update in and it's 1.092 but i dont see the stainless option for temp control
You have to get that through the software program