You can download the help guide from http://www.evolvapor.com/datasheet/dna40.pdf
I haven't read through it, but I would expect all answers are there.
I haven't read through it, but I would expect all answers are there.
You can download the help guide from http://www.evolvapor.com/datasheet/dna40.pdf
I haven't read through it, but I would expect all answers are there.
Yes thanks I have read those instructions and have been using those. Nothing is written in their about temp off. There is a temp off setting for this chip in 3f's xvostick style mods. Might need to be the setting needed for running 3f's mods in power mode
Yes thanks I have read those instructions and have been using those. Nothing is written in their about temp off. There is a temp off setting for this chip in 3f's xvostick style mods. Might need to be the setting needed for running 3f's mods in power mode
Thanks, DP. This is what I was looking for. Looks like the clone has the same functionality as the real Evolve chip. Go figure!!!You can download the help guide from http://www.evolvapor.com/datasheet/dna40.pdf
I haven't read through it, but I would expect all answers are there.
Thanks, DP. This is what I was looking for. Looks like the clone has the same functionality as the real Evolve chip. Go figure!!!
I read on their forum this morning that the FT version does have TC. FT confirmed it. FT has a habit of screwing up descriptions of new items.FT's version does not mention temp control.....does it not have temp control?
I am now getting the ohms too high message as well since I turned off temperature control. My settings are 14.5watts with a 1.21ohm coil. I put in a different RBA with a 1.07ohm coil and am not getting the message. Is there some limit for resistance?Setting temp off did not make ohms too message go away. However it vapes just fine with error message
Yes, I am hoping someone will have fitted a genuine evolv in the clone by the time mine arrives The only clone board DNAs I think are any good are the Kangxin and SKX, the board in the SKX Zero mini looks spot on but a little long winded and expensive to get a clone board to put into a Xvo clone.Does an evolve dna40 chip have a temp off setting?
I've used both (in authentic). The battery cap sticks up a touch with my buttoned ones, but they both work fine.in the authentic I am using flat tops......with mods flat tops are the safest bet they wil fit...use them in all my mods...samsung 25r or sony vtc4 or 5 are good