How many wraps to get a 1.2 ohm coil with 28g twisted kanthal?

[Sil3nt]

Going to use the same diameter as the infamous blue screw driver to wrap around it. Just need a general idea about how many wraps..

 

[PaulBHC]

Depends on the leg length and resistance of the topper. Ever use the steam engine calculator?

 

[Rabbit Slayer]

And twisted meaning, 2 stands, 3, 4, 42??

 

[mackman]

And the coil diameter. Here is everything you need:
Coil wrapping | Steam Engine | free vaping calculators

 

[tedigram]

When you use the steam engine, don't forget to pay attention to the heat flux numbers. It was a couple months before I even noticed it. But once you know what general range of heat flux you like, it becomes a lot easier to calculate how you should build different types of wire when you start playing around.

Most people seem to like a flux of around 200, give or take 10-20. I prefer a cooler vape, so I usually shoot for 160-70.

 

[CMD-Ky]

A big thumbs up to these two posts.

And the coil diameter. Here is everything you need:
Coil wrapping | Steam Engine | free vaping calculators

When you use the steam engine, don't forget to pay attention to the heat flux numbers. It was a couple months before I even noticed it. But once you know what general range of heat flux you like, it becomes a lot easier to calculate how you should build different types of wire when you start playing around.

Most people seem to like a flux of around 200, give or take 10-20. I prefer a cooler vape, so I usually shoot for 160-70.

Going to use the same diameter as the infamous blue screw driver to wrap around it. Just need a general idea about how many wraps..

 

[hurricanegirl100]

Man, seriously?? What gauge Kanthal are you using? What ohm level are you shooting for? Go watch some YT videos...

 

[edyle]

Going to use the same diameter as the infamous blue screw driver to wrap around it. Just need a general idea about how many wraps..

Coil wrapping | Steam Engine | free vaping calculators

15/16 wraps
single coil
2mm
28 gauge; 2 wires twisted (equivalent to dual coil)
55watts@8volts

 

[gmoney$]

Use 32 if u want higher ohms with twisted

 

[gmoney$]

Ohms I mean not wraps

 

[Sil3nt]

Man, seriously?? What gauge Kanthal are you using? What ohm level are you shooting for? Go watch some YT videos...

Read the thread title, 28 gauge pre-twisted kanthal, 1.2 ohm's.

EDIT: Getting a Delta II rba deck.

 

[ThePropaganda]

8 wraps for me around a 2.5mm screwdriver, twisted it till the wire broke at the drill bit