510 cabling

[ktismael]

Greetings forum members,

I'm looking to build a mod and I'd like to be able to have my atomizer separated from my battery. I could solder some existing connectors and run wire between them, although I only seem to find components for the female connectors. But it would much easier if someone made a M-F 510 thread cable. But I can't see anything like that from searching. Is anyone on here familiar with where I could find such a thing or had a similar solution they could point me to?

Thanks for any help you can provide.
KT

 

[breaktru]

You mean something like this: http://www.madvapes.com/510-gooseneck-extension.html

 

[ktismael]

I found that, and it's close, but it is rigid and doesn't give me a lot of options. I'd prefer to find an actual cable rather than a metal gooseneck, or even just both connector ends and I can make my own cable.

 

[drmarble]

You could use two of these adapters: $3.38 510 to eGo Adapters for E-Cigarette (5-Pack) 5-pack at FastTech - Worldwide Free Shipping
They are brass so soldering shouldn't be to hard. You would just have to scrape/sand/file off some of the plating.
Or, get a good 510 connector socket: $1.95 510 Connector w/ Solder Ring Terminal for E-Cigarette - stainless steel + brass / 22mm dia. at FastTech - Worldwide Free Shipping and use the 510 screw in connector off the bottom of some old carto or other unneeded atomizer.