Time to get this party started.......
Are you saying alcohol is not enjoyable
I believe there has been some discussion of a patina resistantMust resist copper!!
(Unless it doesn't patina .... then resistance is just stupid)
Disappointment.I believe there has been some discussion of a patina resistant
finish for the copper. Any further thoughts on that??
I was wondering if anyone could confirm that the following is the right pad.
Sent from my iPhone using Tapatalk
I haven't heard of a finish yet, that the oils in your hand don't wear off over time.I believe there has been some discussion of a patina resistant finish for the copper. Any further thoughts on that??
Tell me more.....please!One could always have copper electroplated with silver or gold.
Very nice!! That's one of my favorite parts!! Nice symmetry as always.Not to change the subject, but........
Magnets!!!
...........................................................
I'm going to pretend the copper on the far right says "for Nate".Not to change the subject, but........
Magnets!!!
...........................................................
I'm going to pretend the copper on the far right says "for Nate".
Sent from my XT1096 using Tapatalk
If you bought some round stock of sufficient diameter enough to make 8-32 screws from scratch, you'd get a lot more swarf.Speaking of silver.........
I've got about 1/10 of a grain of swarf, already!!!