Many thanks for getting back to us @Billie-cig.The top oring of the pin (the one closer to the SS cup) should not go completely in the center hole of the base. It should sit on the inner grove on the center of the base like a cushion (also used for electric insulation). If you changed the o ring with one of the orings provided as an accessory, make sure you didn't put on the one that goes in the bottom of the pin or vice versa. The smaller one goes on the bottom of the pin.
Its highly likely that the liquid doesn't come from the side of the SS cup, but from the center air hole of the cup. Overfeeding and very low positioning of the coil can cause that.
If it appears that the o ring is mangled, let us know and we will change your base.
When machining finishes on the base, the hole where the pin goes in is sharp so it can mangle the o rings, so we smoothen out the edge on that corner by hand. We didn't notice the problem for the first few days, so some bases got out without the last proccess. It's a very simple fix, that can be done with a drill bit or a Philips screwdriver (with the correct diameter of course). Just place the screwdriver/drill bit in the hole, so the angled sides come in contact with the corner (where the base meets the hole) and twist it a few times both ways. We use a 6mm drill bit for steel. I am just mentioning the tip because I hear " can I fix it by myself?" all the time when any problem arises and it's exciting! We can change the base none the less
I don't have a spare o-ring left (I've already swapped it for the spare) and don't have the delicate fingers to drill into the unit. Can I get this to you good folks to work your magic?
On a side note, I am also experiencing an issue with the posts in that they move. No matter how much I tighten it, I notice a little bit of movement after I screw it down - not sure if this is linked at all... I have not experienced any such problems with the V1 which is working like champ. Flavour is always A1 mega.
Sent from my SM-N910F using Tapatalk