Need.. 1 rba (such as rba for kanger toptank/subtank mini *which I used*)
Build coil and wick as desired (or just use the build you have in the kanger now)
assemble rba as usual, but leave the top screw cap off (or take it off if using the existing rba build) *will also work with the screw cap on, but is harder to re-drip the wick*
Need.. 1/4inch (6.35mm) drill bit
Need.. 1 cap from an empty juice bottle (squeeze bottle, not the eye dropper type)
Drill hole through bottom of cap to top
place over the RBA sleeve..
and voila...
Why?
To show off to your nerdy vape cronies.
To test vape on a new rba build without rebuilding the entire tank
To change flavors without having to rebuild the entire coil and wick or mix flavors (as much)
Build coil and wick as desired (or just use the build you have in the kanger now)
assemble rba as usual, but leave the top screw cap off (or take it off if using the existing rba build) *will also work with the screw cap on, but is harder to re-drip the wick*
Need.. 1/4inch (6.35mm) drill bit
Need.. 1 cap from an empty juice bottle (squeeze bottle, not the eye dropper type)
Drill hole through bottom of cap to top
place over the RBA sleeve..
and voila...
Why?
To show off to your nerdy vape cronies.
To test vape on a new rba build without rebuilding the entire tank
To change flavors without having to rebuild the entire coil and wick or mix flavors (as much)
Last edited: