I have a Hcigar Kayfun 3.1 clone that I have been using for over 2 years now. I just did a rebuild a couple days ago and today I went to fill it with my syringe and plastic taper tip, and the fill valve keeps sticking wide open. Anyone have any ideas or methods that I can try to get the dang...
So, I'm in the market for a better Kayfun Lite Plus clone (I use the Tobeco currently), and I'm wondering whether I should get the v1 or v2. I prefer the mouthpiece from the v1 (I hesitate to call it a drip tip), but I like the idea of the dual airflow holes in the v2. I see no point in the...
Here are some pictures of my process of removing the top ring on my VTR. Tools used was a Dremel with flex shaft extension, orange stone bit, course sanding drum, course cutting disk, electrical tape. I started off trying to keep the ring, but open it up enough to accept a Kayfun (Ehpro Kayfun...
I want to buy a kayfun clone and other supplies like wire and juice from only one page/vendor and it would be better if it was from suppliers you know :D
I have rocket rda it is a kayfun 3.1 clone . I want to know what's the best coil built according to the flavour and the best wick set up . I use Vamo v5 so the lowest ohm is 1.2
I have a Kayfun clone that I have been using for the past several months... I always use the same build, 32g kanthal, 10-12 wraps and installed vertically. I also always vape the same juice which is Vanilla Custard by VCV at 100% VG. All of the sudden my kayfun isn't wicking. I use cotton wicks...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.