¿Any sticky thread with o-ring sizes?

[joanquro]

Hi, I'm looking for a thread with o-ring sizes for atomizers. I mean, a thread where people can post the measured o-ring sizes of their atomizers so everybody can have a look and see what size is in order to get them.

I wonder if such a thread exists.

Thanks.

 

[Ryedan]

Hi, I'm looking for a thread with o-ring sizes for atomizers. I mean, a thread where people can post the measured o-ring sizes of their atomizers so everybody can have a look and see what size is in order to get them.

I wonder if such a thread exists.

I have not seen this anywhere here or elsewhere. OTOH, Google 'O-ring size chart' and you'll get O-ring charts for all O-ring sizes. Then all you need to do is figure out which one you need

 

[joanquro]

I have not seen this anywhere here or elsewhere. OTOH, Google 'O-ring size chart' and you'll get O-ring charts for all O-ring sizes. Then all you need to do is figure out which one you need

Ok, thanks a lot.

 

[Spatchka]

While we are discussing O rings, sometimes it helps to having a caliper.
Comes in handy when you want to get a starting point on sizes.

I have a 6" General dial caliper that I use at home.
Does inside, outside and depth measurements. Both Metric and standard.

Lots of uses around the house and work area.