I was given some advice as to what might work with pure VG juice and one of the accomplished members advised the new Fluxomizer at Gotvapes. I stated that I had a 3.7 V battery and he told me that I could go with the 2.4-2.6 ohm fluxomizer. My neighbor just scared me and said that "he wouldn't" go that high as it could burn your battery out in 2 draws........ I need the expert advice is this really true as he seems to know his stuff but I'd rather hear it from the experts.........Thanks!! His response; """I don't know what you've seen in the videos, but the Fuxomizers are the least labor intensive cartomizers out there. You may have been mistaking them for the other CE2's where you need to flip seals and fluff wicks and fill them through a tiny hole. Fluxos work right out of the box. You do need a needle-tip bottle or a syringe, but the top silicon seal is one piece and there aren't the tiny holes. It's squared off to leave a gap for a good sized needle, or a thin drip tip to fit. It takes less time to fill them than to fill a regular filled carto, and like I said, no modding is necessary. Plus, they don't crack or leak. They come in 2.4-2.6, 2.6-2.8 and 2.8-3.0ohms. For a 3.7 battery, I'd get the 2.4-2.6ohm ones. Because the coil is up on top, they feel warmer than a regular cartomizer. Even though 2.4 is not that low a resistance, the vapor will still seem as warm as a LR 2.0ohm Boge carto. It'll just taste a lot better. Quick electronic lesson. If you want to know how warm your vapor will be, remember Watts=Heat. More watts, more heat. To get the watts, you square the voltage and divide by the ohms. You have a 3.7V battery. 3.7 squared is 13.69. So just divide 13.69 by the ohms. That will give you the watts. 13.69/2.5= 5.48 Watts. 5.48 is not very warm, but again, the Fluxos feel warmer than other cartos, so it'll feel more like 6.5 Watts, which is pretty decent for a 3.7V battery. Most of all, it'll taste a lot better than a Boge.""