Any word on the P+ v2?

Discussion in 'Super T Manufacturing' started by HauntedMyst, Jul 10, 2014.

Thread Status:
Not open for further replies.
  1. HauntedMyst

    HauntedMyst Ultra Member Verified Member ECF Veteran

    David, I know you've mentioned you are working on the new version. Will you make a new top cap that is compatible with the old P+?
     
  2. HauntedMyst

    HauntedMyst Ultra Member Verified Member ECF Veteran

    I guess not.
     
  3. snork

    snork Vaping Master Verified Member ECF Veteran

    Bump this question.
     
  4. forcedfuel50

    forcedfuel50 Forum Supplier ECF Veteran

    I have an idea of the new V2 P+ in my head, just haven't put it into the mix yet. Keep meaning too. The cap though would probably not be compatible with the old, as I'd make an adjustable post on it which would probably change the length, plus I may change the thread too.
     
  5. HauntedMyst

    HauntedMyst Ultra Member Verified Member ECF Veteran

    I hope you don't change the width. As much as I use the ELA at my desk, I use two P+ on the go and it's best feature aside from it's dependability is it size. The only thing it lacks is a the adjustable center post (and if you can get the locking mech to stay aligned). Combined with the Taifun GS, it's an outstanding portable device.

    DSCF8603.jpg
     
  6. UKPaul

    UKPaul Ultra Member Verified Member ECF Veteran

    Supporting member
    For me a P+650 @ 22mm x as short as poss overall length would be cool so I can run my VTC5's in it.

    With a concave bottom button :)

    Same cap, button and body finish as the V1 P+ :)
     
Thread Status:
Not open for further replies.

Share This Page