Atlantis 2 help

[Freq18Hz]

All,

I'm a little confused about the following guidance from Aspire for the Atlantis 2:

• 0.3ohm, power with 60-70 watts
• 0.5ohm power with 20-30 watts
• 1.0ohm power with 40-50 watts

Why would 1.0ohm need more watts than the .5? I'm currently using a Matrix sub battery with the .3 coil. Is it safe to use the .3 coil with this battery?

Can someone recommend a mod / wattage to run the .3 and .5 coils at? I also have a Matrix sub clearomizer with a .2 and .6 coil.

Noticing that with both the Atlantis 2 and the Matrix, battery life on this 2000mah Matrix sub kinda sucks.

Any recommendations/help?



-Freq

 

[boandlkramer]

Pretty sure it has something to do with the build of the different coils. I don't recall where I read it here, but the .5 ohm ones use a differentwire. [HASHTAG]#Experts[/HASHTAG]?

"they (Aspire) use nichrome wire and if you look closely theirs is a no resistance and resistance wire build with the two legs as no res wire and the central heating coil resistance wire."

 

[lovemytank]

I would venture besides the fact that Aspire rocks yet their technical writers mispell a bunch of words, it has to do with higher resistance needs more power to get hot, yet the juice holes dont flow fast enough for high a wattage on the .5 but do for the .3 since the flux capacitor is radiated with vermiculite?