best vape for chi-you/zau combo

Discussion in 'New Members Forum' started by Lexter, Mar 13, 2013.

Thread Status:
Not open for further replies.
Image has been removed.
URL has been removed.
Email address has been removed.
Media has been removed.
  1. Lexter

    Lexter Full Member Verified Member

    Joined:
    Feb 10, 2013
    Location:
    United States
    any suggestions on coilings?
     
  2. Blix

    Blix Ultra Member Verified Member ECF Veteran

    Joined:
    Jan 8, 2013
    Location:
    Stabekk, Norway
    500# mesh unoxidized, 4/3 wrap with 28g Kanthal A1 and you should be well set. :)
     
  3. Lexter

    Lexter Full Member Verified Member

    Joined:
    Feb 10, 2013
    Location:
    United States
    unoxidized? wouldnt that cause a short?
     
  4. crisdeguzman

    crisdeguzman Full Member

    Joined:
    Mar 11, 2013
    Location:
    Walnut, California
    im pretty sure unoxidized will short...
     
  5. Blix

    Blix Ultra Member Verified Member ECF Veteran

    Joined:
    Jan 8, 2013
    Location:
    Stabekk, Norway
    Nope. :) One might think so, but done righ you don't. What I do is just quickly going over the mesh with a lighther to burn off any factory crud, then I roll the wick. The you make your coil and then you just pulse it until you have a even coil around the wick. It's almost magic. :)
     
  6. Blix

    Blix Ultra Member Verified Member ECF Veteran

    Joined:
    Jan 8, 2013
    Location:
    Stabekk, Norway
    Take look in the RBA section, unoxidised wicks are the new "hot" thing to do. ;)
     
  7. crisdeguzman

    crisdeguzman Full Member

    Joined:
    Mar 11, 2013
    Location:
    Walnut, California
    i should try that... but wouldn't it give you a metallic taste?
     
  8. Blix

    Blix Ultra Member Verified Member ECF Veteran

    Joined:
    Jan 8, 2013
    Location:
    Stabekk, Norway
    Nope, it even eliminates the "break-in" of a wick and gives you great flavor from pretty much the first puff. :)
     
  9. Rabe

    Rabe Full Member

    Joined:
    May 10, 2012
    Location:
    Berlin / Germany
    Thats new to me 2. Thanks for the hint! I always oxidate the mesh and sometimes i have shorts even with the oxidated... I will try it!
     
  10. crisdeguzman

    crisdeguzman Full Member

    Joined:
    Mar 11, 2013
    Location:
    Walnut, California
    im gonna try that right now. HAHA thats gonna save me so much time
     
  11. Blix

    Blix Ultra Member Verified Member ECF Veteran

    Joined:
    Jan 8, 2013
    Location:
    Stabekk, Norway
    Check out Todd trying it:

     
  12. Lexter

    Lexter Full Member Verified Member

    Joined:
    Feb 10, 2013
    Location:
    United States
    Nice! lemme try doin it.. hope i wont short out.. don't have a 2cent on my device xD
     
Thread Status:
Not open for further replies.

Share This Page