Coil priming question?

[Benjamin89]

Since starting at low wattages is recommended for breaking in coils, how can one do this if they are using an ego non vw/vv device? Does the coil require more soaking time?

 

[r77r7r]

Since starting at low wattages is recommended for breaking in coils, how can one do this if they are using an ego non vw/vv device? Does the coil require more soaking time?

It already IS low power. If it's an unregulated type, don't try it when fully charged.

 

[zoiDman]

Since starting at low wattages is recommended for breaking in coils, how can one do this if they are using an ego non vw/vv device? Does the coil require more soaking time?

If you Can't change the Voltage or the Wattage then you just have to go with what you got.

And letting the Coil soak an Extra Minute or Two isn't a bad call.

 

[JoeMischief]

If you Can't change the Voltage or the Wattage then you just have to go with what you got.

And letting the Coil soak an Extra Minute or Two isn't a bad call.

As above... To be fair you won't do any harm soaking it too long. I think most of the recommendations will say 10-15 mins if you want to be sure. Better over than under. IMHO of course...

 

[Smoke_too_much]

As suggested go with a bit more wait time then take a few draws with the airflow shut down and no fire power. Then open the air again and do a draw with a quick fire only. If it tastes good then fire it longer as you like.