Cover Your Hole!

Discussion in 'Tips and Tricks' started by Sweet_Afton, May 13, 2008.

Thread Status:
Not open for further replies.
Image has been removed.
URL has been removed.
Email address has been removed.
Media has been removed.
  1. Sweet_Afton

    Sweet_Afton Full Member

    Joined:
    Apr 10, 2008
    In the past few weeks I have been experimenting with covering the hole on the atomiser when dragging.

    I usually start with the e cig by putting my finger over the hole and sucking in hard.Then i take my finger off the hole.
    With new e liquid loaded this usually produces a lot of vapour, so much so that your throat can hurt.The atomiser seems to super heat and my e cig led light warns I have inhaled too much.

    Sometimes you will get no vapour and sometimes the vapour can smell bad.

    You can experiment too by tapping on the hole with your finger as you inhale and seeing if that works well.

    Anyone else tried this technique?
     
  2. leaford

    leaford Supplier Services Provider ECF Veteran

    Joined:
    May 1, 2008
    Location:
    Shenzhen, Guangdong, China
    None of mine have a hole.
     
  3. jarvis

    jarvis Senior Member ECF Veteran

    Joined:
    Apr 28, 2008
    Location:
    Tx
    As I understand it, these holes are there to keep your e-cigarette from overheating, so be careful not to burn out your atomizer.
     
  4. Sweet_Afton

    Sweet_Afton Full Member

    Joined:
    Apr 10, 2008
    Thanks for that tip.I thought that was the case as the atomiser seems to heat up
    an awful lot when you do it.I find it good to do once or twice to get things going.

    Cheers!
     
  5. rustylug

    rustylug Unregistered Supplier ECF Veteran

    Joined:
    Aug 24, 2008
    Location:
    Aberdeen, Scotland
    I made a video a few weeks ago on just this very subject.
    Will post the video again for anyone who missed it.
    You can only do this if your atomiser has more than 1 hole.

    YouTube - electronic cigarette super mini


     
  6. SANJP

    SANJP Senior Member ECF Veteran

    Joined:
    Oct 14, 2008
    Location:
    LONDON UK
    yep it works wonders and gives a solid throat kick everytime on the DSE901B

    but sure it reduces the life of the atomiser as when using this technique

    it gets hot as hell !:evil:
     
  7. PuffnStuff

    PuffnStuff Full Member

    Joined:
    Oct 21, 2008
    Location:
    La Verne, California (US)
    Since the pneumatic switch is in the battery and is now getting all the pressure of your draw instead of the partial pressure it would normally get. Couldn't this method destroy the switch in the battery?
     
  8. zaphod

    zaphod Full Member ECF Veteran

    Joined:
    Nov 12, 2008
    Location:
    Sofia, Bulgaria
    What I do is not to block the hole on my dse901 for a long time but instead tap it a few times. This way I block it for a fraction of the second a few times and not letting the heater to get very hot. The efect tough is huge. I get much better smoke amounts!
    and its not getting hot.
    Also this method allows me to smoke with a weak battery. Without doing this I found that I can use the batteries for a very short time before they stop making good smoke. With this I can make most of the battery's charge :)
     
  9. rustylug

    rustylug Unregistered Supplier ECF Veteran

    Joined:
    Aug 24, 2008
    Location:
    Aberdeen, Scotland
    I have also tried this .... and it works with the DSE901 .... But my point on the video " Which mabey i didnt say was" .... The Super Mini has 2 holes ...A bit like a silkcut has lots of holes :)
    I just tried covering 1 hole .... You cant do that on the DSE901 because it only has 1 hole :thumb:


     
  10. zaphod

    zaphod Full Member ECF Veteran

    Joined:
    Nov 12, 2008
    Location:
    Sofia, Bulgaria
    Ohh I've seen it but Im talking in general. I find dse901 smoke not very satisfying except when used with fresh battery and new cartrige... I thing this technology has yet a lot to achieve ... there are a hell lot of small annoyances ....


    P.S. By the way u have great accent.. reminds me Dr. Beckett from Stargate Atlantis ... very nice... where are u from?
     
  11. Somoney

    Somoney Senior Member ECF Veteran

    Joined:
    Oct 9, 2008
    Location:
    USA
    I do this also some times. I'll cover the hole, only giving enough suction to turn the battery on for about 1-2 seconds, then ill take my finger off the hole to continue the hit. This is another way to get your atomizer heated up faster. I dont do this all the time because I'm affraid Ill ruin the pressure switch on my battery.

    I've also taken a hit from the breather hole directly. Its a dryer type of hit as it draws your vapor directly from the atomizer.
     
  12. Soot

    Soot Super Member ECF Veteran

    Joined:
    Oct 11, 2008
    Location:
    Belfast, UK
    "Sweet Afton" - them's the cigs my old grandma smoked. Are they still made?

    (Can I call you "Gran"? ;))
     
Thread Status:
Not open for further replies.

Share This Page