I'm sure there are other RDAs that are like this but I don't have any.
The negative post on the double vision rda is press-fit, so the tiniest bit of extra tug causes it to pull out.
Basically, does anyone have any suggestions besides a dot of glue (unsafe?) or just holding down the negative while I'm tightening, which is what I do now? Still not great. I mean I have a ton of RDAs but I just happen to like the DV.
Thanks in advance.
The negative post on the double vision rda is press-fit, so the tiniest bit of extra tug causes it to pull out.
Basically, does anyone have any suggestions besides a dot of glue (unsafe?) or just holding down the negative while I'm tightening, which is what I do now? Still not great. I mean I have a ton of RDAs but I just happen to like the DV.
Thanks in advance.