When i ordered my e2's I got 5 3.0's and 5 2.5's. I tried the 2.5 and it produced nicely except for the usual wicking problem. I tried the 3.0 and instant burn. I put them on a multi-meter and they were reversed in their ohm's. Has anyone had this happen to them?
e2 carto switch
- Thread starter rusalka
- Start date
- th_trl_thread_readers 0
- Status
doesnt matter whether they are reversed or not. Current doesn't care which way its travelling, in this case, your coil, looking down at it, either has the current going one way or the other through it. As long as your meter is telling you that you have a resistance value in range, you're good to go.
Their ohm readings have always been a bit off. I have some from the same pack that vary from 2.5 - 2.9 ohms.
- Status
Similar threads
- Locked
