Went through quite a bit of wire trying this microcoiling method. Is there an easier way to do it? I'm trying to run a dual coil on my chimbus and aga t2 with hopefully a resistance of under 1.
The point of the microcoil is to have the feeling of a sub ohm coil that runs on a regulated device i.e. above 1.2. I use 30g kanthal with 10 wraps and end up between 1.8-2.1
Dual 30 gauge, with 8-10 wraps will net you 1 ohm setup, make sure you are using a drill bit or something similiar to make your coils. 32 is going to be hard to get a lot of wraps in there without being higher resistance. Good luck
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.