Howdy All!
So, I am a bit on the OCD side thought it would be interesting to see how everyone here stores/carries their vape gear? And yes, I like lists.
know this thread has been done before, but just can't find it...
the pic below is how I store my mech mod, I usually take out the battery and store it in the front pocket with the mod inside the zippered padded compartment. It is a case logic soft case for a small external hard drive.
The striped grey pencil bag is where I store all my re-building supplies, nice and compact. I found these colored rubber band type things (supposed to go around your mech mods) that have super lame "vape mottos" on them, and I turned them inside out and put them around my unicorn bottles so that I know which juice is which.
my rebuilding supplies, finally got it down to the bare necessities as I was carrying around a crap load of tools before:
1) cellulose for wicking and qtips for cleaning my rda's and driptips
2) ohm meter
3) two double pointed knitting needles (2mm in diameter) for making my coils
4) a pair of ceramic tipped tweezers
5) a zero sized phillips screwdriver
6) this weird cuticle pusher that is perfect for position my wicks
7) kanthal wrapped around a plastic no untangle bobbin
8) an angled close cropped wire cutter, more accurate then a nail clipper
9) a small pair of scissors for cutting my cellulose
So, I am a bit on the OCD side thought it would be interesting to see how everyone here stores/carries their vape gear? And yes, I like lists.
know this thread has been done before, but just can't find it...
the pic below is how I store my mech mod, I usually take out the battery and store it in the front pocket with the mod inside the zippered padded compartment. It is a case logic soft case for a small external hard drive.
The striped grey pencil bag is where I store all my re-building supplies, nice and compact. I found these colored rubber band type things (supposed to go around your mech mods) that have super lame "vape mottos" on them, and I turned them inside out and put them around my unicorn bottles so that I know which juice is which.
my rebuilding supplies, finally got it down to the bare necessities as I was carrying around a crap load of tools before:
1) cellulose for wicking and qtips for cleaning my rda's and driptips
2) ohm meter
3) two double pointed knitting needles (2mm in diameter) for making my coils
4) a pair of ceramic tipped tweezers
5) a zero sized phillips screwdriver
6) this weird cuticle pusher that is perfect for position my wicks
7) kanthal wrapped around a plastic no untangle bobbin
8) an angled close cropped wire cutter, more accurate then a nail clipper
9) a small pair of scissors for cutting my cellulose
Last edited: