GG drip tips
- Thread starter imeothanasis
- Start date
- th_trl_thread_readers 0
- Status
Make more!!! I only was able to grab the curved one. I need ALL of them!!
GEEEE ... not even this one made it to my home - but I am pretty confident and believe in the ZEN of my GG spirits
one day ... just one fine day ... they all will be mine 
ahhhhhhhh STELIOSSSSSSSS ... I will not give up and I will not give in ... 
Hi Imeo,
just wondering, in this new batch of GG Drip Tips, did you include the Delrin (plastic) drip tips?
just wondering, in this new batch of GG Drip Tips, did you include the Delrin (plastic) drip tips?
Unfortunately not Ariel. I was ready to make them but the big batch of the upcoming Tilemahos prevented me to do it
Unfortunately not Ariel. I was ready to make them but the big batch of the upcoming Tilemahos prevented me to do it
No problem
I'm very happy because you made the 4 SS ones (unfortunately I was unable to get them on the first batch).
Yes, no curved buddy. I notice that only 20% of customers bought it, so I didnt make them again on this batch.
Come back home after 15 days, find in my box my new short GG drip tips 
Imeo should it possible to made later a short one, straight (without the shrinkage of bottom) and a bigger air hole?
And engrave the GG in the same direction than Esterigon
Imeo should it possible to made later a short one, straight (without the shrinkage of bottom) and a bigger air hole?
And engrave the GG in the same direction than Esterigon
I had to put smaller o-rings on my drip tip because it was too tight. After you put it in it's almost impossible to get it out without rubber gloves, also you put alot of stress on LC section to the point that it feels like you will bend it or strip the threads.
I used 5x1,5
Right now it's much better-LC is turning and the driptip gets easily on-off
I used 5x1,5
Right now it's much better-LC is turning and the driptip gets easily on-off
good solution Beco. I had to make it tight, so you would be able to make it less tight. If I had done the opposite, there would be no solution for people that want it very tight
that too Stelios. Another solution too is to put one 6x1,5 and one 5x1,5
Like the new drip tip . Is the bore the same size as the solid MP of Penelope 3 for example? Would like to try it if it will be available individually
Edit: I'm asking this from Imeo, obviously
. Is the bore the same size as the solid MP of Penelope 3 for example? Would like to try it if it will be available individuallyEdit: I'm asking this from Imeo, obviously
Ok. By bore I meant the internal diameter of the drip tip. Penelope's MP bore is around 4mm I think. I was asking what is it for this new white drip tip. Also curios what material it is since I didn't see this mentioned anywhere
Ah, ok pro
internal diameter starts at 4,5mm in 7mm length and ends at 3mm in the rest of the length
internal diameter starts at 4,5mm in 7mm length and ends at 3mm in the rest of the length
- Status