Got a question......

[Cheryl75]

On a rm2, a post broke off as i was putting on a new coil. Snapped off right at the ceramic base. Can it be fixed or is it a gonner?

 

[bsidb]

They thread in and out, I think if you can get the rest of the post out you could replace it

 

[bsidb]

If you un screw the post near the juice hole and un screw the 510, the ceramic will come out, maybe you could drill out the post,

 

[Cheryl75]

Ok, thanks for your reply @bsidb

 

[tobarger]

Sounds like if you disassemble the RM2 to remove the ceramic the broken post can be removed with pliers. Then email or PM Rob (redeyedancer) for a replacement post, he'll take care of you, he took care of me with the same situation.

 

[Cheryl75]

Sounds like if you disassemble the RM2 to remove the ceramic the broken post can be removed with pliers. Then email or PM Rob (redeyedancer) for a replacement post, he'll take care of you, he took care of me with the same situation.

Thanks!! Thats what i was hoping for

 

[tobarger]

You've got a shot
Hopefully the ceramic will slide off the broken post
I'm assuming the negative post is the one broken
May have to push up on the ceramic with a small screwdriver or punch through the 510 after the positive contact is removed
RM2 FULL atomizer itself rebuild (Pic heavy)
Just remember that the round metal piece that the positive contact and positive post screw into is shown installed wrong(in picture 3 & 5), it should be flipped over

 

[Cheryl75]

Much appreciated @tobarger !!! Not something i will attempt myself, was just hoping/wondering if it is a fixable issue. Will leave the fix, if possible, to the mod master!