heatsink wont read

Status
Not open for further replies.

tony7432

Super Member
Verified Member
Jun 15, 2015
383
206
46
Sydney nsw australia
I ordered a brass heatsink for my fuhattan. What are you using it on? I'm just curious they seem like a good idea as just a thread saver alone
picked up two, one for the freemax starre and the other for the atlantis V2, but i think i will order 3 more, one for my rda, one for the atlantis mega i ordered last night and one more for the smok tfv4 i have on pre order.
 

tony7432

Super Member
Verified Member
Jun 15, 2015
383
206
46
Sydney nsw australia
So you're leaving them attached to the tank? I plan on just leaving it on the mod and swapping the tanks
yeah im just going to leave them on the tanks, so each tank has its own and that way i dont have to worry about the threads on the tank since those wont ever get screwed or unscrewed anymore it will be the threads on the heat sink
 

tony7432

Super Member
Verified Member
Jun 15, 2015
383
206
46
Sydney nsw australia
I'm more worried about my mod since my fuhattan is aluminum so the threads aren't as strong as steel. My ipv mini 2's threads for ruined by my gf's cousin so I had to replace the 510 too, and that's more expensive to replace than a tank lol
sounds like more then a good excuse to buy another mod ;)
 
Status
Not open for further replies.

Users who are viewing this thread