Help Disassemble Vamo V2

Discussion in 'VAMO' started by rjs987, Jan 3, 2014.

Thread Status:
Not open for further replies.
Image has been removed.
URL has been removed.
Email address has been removed.
Media has been removed.
  1. rjs987

    rjs987 Senior Member Verified Member ECF Veteran

    Joined:
    Mar 19, 2013
    Location:
    None
    I have a vamo v2 and i cannot get the top part to "wiggle" off. I have seen this video Vamo first impression and disassembly how to - YouTube and this guys seems to do it very easy. Has anyone else had trouble trying to get the top part off? This has been frustrating me any advise would be appreciated. Thanks
     
  2. Nu2Dis

    Nu2Dis Super Member Verified Member ECF Veteran

    Joined:
    May 24, 2013
    Location:
    Jersey Shore, NJ, USA
    It worked for me when I tried it. I didn't have good enough protection inside the pliers and scratched it up a little. It is press fit on, so it's gotta give at some point. Just be careful, the wires are pretty short inside the head. It may have looked easy in the video, but i'm sure it wasn't the first time he actually did it on that device.
     
  3. rjs987

    rjs987 Senior Member Verified Member ECF Veteran

    Joined:
    Mar 19, 2013
    Location:
    None
    Thanks,

    I have scratched mine all up and didnt even get it to budge. Which type of pliers do you recommend?
     
  4. Nu2Dis

    Nu2Dis Super Member Verified Member ECF Veteran

    Joined:
    May 24, 2013
    Location:
    Jersey Shore, NJ, USA
    I used a pair of channel locks; they had round jaws, not the flat kind; the bigger the better.

    channel locks.jpg
     
  5. WarHawk-AVG

    WarHawk-AVG Vaping Master ECF Veteran

    Joined:
    Jul 27, 2013
    Location:
    H-Town
    and wrap the tube in a shop towel or something to prevent marring/scratching

    Good Luck
     
  6. K_Tech

    K_Tech Slightly mad but harmless Verified Member ECF Veteran

    Supporting member
    Joined:
    Sep 11, 2013
    Location:
    Eastern Ohio, USA
    I'd suggest one of those cheap jar lid rubber thingies. I think that's the right word for it. Provides a little more grip than a shop towel.
     
Thread Status:
Not open for further replies.

Share This Page