Ma 1ere resistance iclear 30 ecigarette fr - YouTube
its in french so you can mute and just watch....
it gives you a good idea on what to do
its in french so you can mute and just watch....
it gives you a good idea on what to do
- Status
Tried this an my svd keeps telling me 0.0R
I am pretty sure it's due to my inability to trim the wires short enough for the negative leads. I used nail clippers and scissors but idk, something's not right.
Anyone else have any tips or good quality english videos on how to rebuild these heads?
I am pretty sure it's due to my inability to trim the wires short enough for the negative leads. I used nail clippers and scissors but idk, something's not right.
Anyone else have any tips or good quality english videos on how to rebuild these heads?
Tried it with a single wick and coil on my iclear16 and it reads .5R (I ordered 1.8ohm wicks and coils from FT)
....
....
I gave it another chance last week. I used res-nores i welded together and made 2 coils of 3 Ohm with it. The welding was a pain. Putting the coils into the holder was a pain. And when i finally managed to close everything up i tested the coil and it read.... 0.0 Ohm.
It took me over 2 hours to get this far, so that was also a pain. I threw it in the garbage can and decided that when i use my iClear30 again (which will hardly happen since i use Kayfun Lite+ now) i will just buy new coil heads.
It took me over 2 hours to get this far, so that was also a pain. I threw it in the garbage can and decided that when i use my iClear30 again (which will hardly happen since i use Kayfun Lite+ now) i will just buy new coil heads.
- Status
Similar threads
- Locked
