Innokin iTaste 134 VW MOD Starter Kit with I30 Clearomizer $119.99!

Discussion in 'EcigBestSave' started by akovac1939, Jun 9, 2014.

Thread Status:
Not open for further replies.
Image has been removed.
URL has been removed.
Email address has been removed.
Media has been removed.
  1. akovac1939

    akovac1939 Forum Supplier ECF Veteran

    Jan 29, 2010
    The Innokin iTaste 134 Kit with iClear 30 included! is the newest of Innokin products combined into a kit.. Only designed for Unprotected 18650 battery. The iTaste 134 Mod comes with a 510/eGo connector and will work with your favorite clearomizers with 510/eGo threading.

    It has following new features with explanations below:

    1. Variable Wattage: the rotational wheel adjusts wattage by increments, various wattage are for you choice(7.0,8.0,8.5,9.0,9.5,10.5,11.0,12.0,12.5) The red LED will blink six times and turn off if the rotational wheels placement is incorrect.

    2. Battery capacity display: the battery capacity is displayed via green,yellow and red LED light.
    Green=Fully charged.
    Yellow=Half charged.
    Red=Charge Needed.

    3. Voltage display: when a single battery is installed, various LED lights blink in different patterns indicating the voltage it is in.
    Green=voltage higher than 3.75V
    Yellow=voltage around 3.6V-3.75V
    Red=voltage lower than 3.6V

    4. Low voltage warning: the red led will keep blinking for eight seconds when batery capacity is lower than 3.3V and automatically power off. Red led will stay lit for five seconds if a load short circuit is deteched, after which no vapor will be producted.

    5. 10-seconds cutoff:If the button is held down for 10 seconds or loner,the iTaste 134 mini will automatically power off until the button is released and pressed again.

    iTaste 134 18650 Mod also shares same features with other mods:
    1. On/off battery switch, press the switch three times to turn on/off the mod.
    2. Short Circuit Protection(0.6+/-0.2ohm).
    3. Battery Safety Protection (Vent holes).

    Technical Specifications:
    The standby current:150uA maximum
    Maximum output voltage:6.0V(unloaded)
    Maximum output current:5.0A(Built in 7A fuse for protection and stability)
    Maximum output wattage:12.5W(Watts mode)

    1, it can only use UNPROTECTED 18650 battery, Can NOT use18350 and 18500 li-ion batteries.
    2, the body of the mod is not detachable,the tube for 18650 battery is fixed.

    Brand: Innokin
    Unit: 1 Set
    Color: Black/Stainless
    Material: Zinc alloy
    Size: Height 5.75"; Diameter 1.10"
    Package: Luxury Box

    Each set contains:
    1pc iTaste 134 18650 Mod
    1pc iClear 30 (Clear)
    1pc Beauty ring
    1pc English Manual
    1pc Luxury box
Thread Status:
Not open for further replies.

Share This Page