Introducing the fasttech dna30 hana

Status
Not open for further replies.

Varelse

Senior Member
ECF Veteran
Jan 21, 2014
114
79
Western Central IA
After my Cana died around a week of use and I ruined my warranty I went to FT for a replacement-less expensive and a much better return policy.

My FT HCigarana 30w shipped 7-4 and I got it yesterday. Right off the bat I noticed it felt 'different'. A little lighter? Smaller? Can't put my finger on it yet.

Battery looks slightly different than my other 2 2500MaH purple efests but that means nothing.

It's reading .1 Ohm high on my 1Ohm and under builds. Don't know about my 1.5's haven't tested those. 501 connector sits a little too high-a few tips where a full atty lands first can't be good.

Can't flip the display but can lock power. Buttons feel fine. Not as clicky as the chana-seem a tad bigger. Can see through the hcigar window, not near as much glue inside. Chana guts were completely encased in epoxy. (Probably why it failed)

Fires on one click but it does pause a bit first. Also have had some volt spazing-at 25w.6 resistance (that reads .7) voltage bobs back and forth between 3.9 and 4.1. Hopefully just need to mess with 510 pins.

For the money I'm currently stoked. This thing is kicking NT Virus vapor out like a coal train.
 
Status
Not open for further replies.

Users who are viewing this thread