The costs of running this huge site are paid for by ads. Please consider registering and becoming a Supporting Member for an ad-free experience. Thanks, ECF team.

IPV4S - Temp Control - Stainless Steel

Discussion in 'APV and Mods Discussion' started by 6stringsNvape, May 25, 2017.

Thread Status:
Not open for further replies.
Image has been removed.
URL has been removed.
Email address has been removed.
Media has been removed.
  1. 6stringsNvape

    6stringsNvape Full Member

    Mar 30, 2017
    Hi all,

    I have an IPV4S mod with a Uwell Crown (gen 1) tank. Typically I have .25 ohm stainless steel coils for the mod, and am wanting to try temp control (or Joule mode) on the device.

    However, the Joule mode on the IP on has options for Ni or Ti coils, and no SS option.

    Is there any way of safely doing TC on it using SS coils, or would it be better to just get a Ti coil or two for it?

    Any info would be greatly appreciated!
     
  2. MaxximusRevelation

    MaxximusRevelation Senior Member ECF Veteran

    Jul 12, 2016
    While stainless steel can be used in TC a Google search made me come to the conclusion that the IPV4S never got the firmware upgrade to give it TC options with SS, which was 8 months after the mod was released so chances are you won't ever get that option with that device.
     
  3. GeorgeS

    GeorgeS Ultra Member ECF Veteran

    Supporting member
    May 31, 2015
    Oregon, USA
    I just use TI and NI200 with the IPV4S. It works well.

    Or simply use power mode. While rather large by todays standards it is a dual 18650 so will have ~2x the run time as a single battery mod.
     
Thread Status:
Not open for further replies.

Share This Page