Just recieved Hadaly, and can't open it, does anybody else have this?

Discussion in 'RDA' started by Nayngnottz94, Dec 29, 2016.

Image has been removed.
URL has been removed.
Email address has been removed.
Media has been removed.
  1. Nayngnottz94

    Nayngnottz94 Super Member Verified Member

    Oct 6, 2016
  2. Nomoreash

    Nomoreash Vaping Master Verified Member ECF Veteran

    Aug 9, 2010
    Chattanooga, TN
    Mine was initially tight. Had to screw it on a mod to get the cap off but it did come off. If that doesn't work might want to try soaking it in really warm water, that might soften up the o-rings, be sure to twist as you pull.
     
  3. Nayngnottz94

    Nayngnottz94 Super Member Verified Member

    Oct 6, 2016
    Got it off do i just lube it with vg?
     
    Train2 likes this.
  4. Nomoreash

    Nomoreash Vaping Master Verified Member ECF Veteran

    Aug 9, 2010
    Chattanooga, TN
    Mine have loosened up bit but still tight. I usually put a thin coat of eliquid around the o-ring before puting on the cap, seems to help some. The top o-ring is ok on mine it's the bottom that's the tightest. Just remember to twist as your pulling it off or putting it on. If you just press or pull without twisting could damage the O-rings.
     
  5. Train2

    Train2 ECF Guru Verified Member ECF Veteran

    May 11, 2013
    CA, USA
    I actually keep a tiny bottle of straight vg handy, to lube RDA's after cleaning.
    just 1 drop, then a finger slide around the o-rings so they're not going on dry...


     
    zoiDman and Nayngnottz94 like this.
  6. Nayngnottz94

    Nayngnottz94 Super Member Verified Member

    Oct 6, 2016
    Gunna get a build on there now.... which build would you recommend @Train2 @Nomoreash
     
  7. Nomoreash

    Nomoreash Vaping Master Verified Member ECF Veteran

    Aug 9, 2010
    Chattanooga, TN
    I recommend whatever works for ya, everyone prefers something different. I use twisted 316ss, 36ga, spaced. If your not sure start out with a normal spaced coil and go from there.
     
    Nayngnottz94 and Train2 like this.
  8. Dan_nj

    Dan_nj Full Member Verified Member

    Nov 14, 2016
    I ended up taking the bottom oring off lot easier. Fused Clapton in mine. Great vape
     
    Train2 and Nayngnottz94 like this.
  9. Train2

    Train2 ECF Guru Verified Member ECF Veteran

    May 11, 2013
    CA, USA
    Agreed - me, I run a 1-battery mech squonker mostly, so I need low mass...
    I think my Hadaly is sporting a 24 gauge 5-wrap, 3mm.

     
    Nayngnottz94 and Izan like this.
  10. Highwayman1224

    Highwayman1224 Ultra Member Verified Member ECF Veteran

    Apr 9, 2012
    Goodyear, AZ
    I was able to pull it apart with my fingers straight outta the package. They must've changed orings or something within the last few months.
     
    Kprthevapr likes this.

Share This Page