Kanger 1.5 Ohm Evod, PT 1/2, etc. Coil Heads available?

Discussion in 'Clearomizers' started by dodari, Aug 10, 2013.

Thread Status:
Not open for further replies.
Image has been removed.
URL has been removed.
Email address has been removed.
Media has been removed.
  1. dodari

    dodari Ultra Member Verified Member ECF Veteran

    Joined:
    Dec 4, 2011
    Location:
    New Mexico
    Somewhere I thought I saw where Kanger was going to make 1.5 Ohm Coil Heads available for the Evod, ProTank 1/2 and the others that it will fit.

    Does anyone know and have tried them? Do they Ohm out at pretty close to !.5 Ohms? The 1.8 Ohm ones I've gotten are all over the place, usually higher than advertised, sometimes .7 Ohms higher. Crappy QC.
     
  2. SupplyDaddy

    SupplyDaddy Ultra Member Verified Member ECF Veteran

    Joined:
    Oct 21, 2012
    Location:
    San Antonio, Texas
    Kanger makes the following coils:
    1.5 Ohms 1.8 Ohms 2.2 Ohms 2.5 Ohms each for the-
    Kanger Protank 1&2, Mini Protank 1&2 heating coil
    Kanger E-vod heating coil
    Kanger MT3S / T3S heating coil

    (All three are still shown on their wholesale pages, but expect to see the evod coils disappear according to the next statement)

    They state the following:
    Bottom coil for Kanger Protank & mini Protank are compatiable with Kanger E-VOD coil.
    Kanger T3S,mini T3S and MT3S use the same bottom coil.

    Factory page Electronic Cigarette,kanger,E-Cigarette,E-Cigs,quit smoking,Health Cigarette
    Wholesale page KangerTech

    The coils I have are for T3S and evod specifically, although I have been able to switch both to the other.
    I've not had a factory coil vary more than .2 ohms.
     
  3. seeber

    seeber Full Member

    Joined:
    May 7, 2013
    Location:
    Los Angeles
  4. dodari

    dodari Ultra Member Verified Member ECF Veteran

    Joined:
    Dec 4, 2011
    Location:
    New Mexico
: evod, protank
Thread Status:
Not open for further replies.

Share This Page