Kanger Coil Grommet Fix

Discussion in 'General Vaping Discussion' started by Sthur, Nov 9, 2013.

Thread Status:
Not open for further replies.
Image has been removed.
URL has been removed.
Email address has been removed.
Media has been removed.
  1. Sthur

    Sthur Vaping Master Verified Member ECF Veteran

    Joined:
    Aug 14, 2013
    Location:
    Denver
    I have seem a few people asking about replacement PT coil rubber grommets.

    I had some free time today to run through Home Depot. I found the following o-rings 10 pack for 2.27 plus tax. I tried it on my PT2 coil and fresh made EVOD coil with cotton wicks. Both working good, no leaks.

    Hope this helps and Happy Vaping!
     

    Attached Files:

  2. Sizzorfite

    Sizzorfite Full Member

    Joined:
    Jul 30, 2013
    Location:
    Westminster, CA
    That's a neat idea. :)
     
  3. Sthur

    Sthur Vaping Master Verified Member ECF Veteran

    Joined:
    Aug 14, 2013
    Location:
    Denver
    Bump :) working good day later. No leaks.
     
  4. Huckleberried

    Huckleberried Ultra Member Verified Member ECF Veteran

    Joined:
    Oct 10, 2013
    Location:
    Louisville, KY, USA
    Bumping again, since I'm trying one myself right now.

    So far, so good. If anyone can't find the exact one at Home Depot, mine says #60 O-Ring with the same measurements as Sthur's.
     
  5. crxess

    crxess ECF Guru Verified Member ECF Veteran

    Joined:
    Sep 20, 2012
    Location:
    Williamsport Md
    Probably 3x thicker than the cup seal, but Hey if it works it works!:)
     
  6. Huckleberried

    Huckleberried Ultra Member Verified Member ECF Veteran

    Joined:
    Oct 10, 2013
    Location:
    Louisville, KY, USA
    True, it's quite a bit thicker. It's a snug fit on the chimney, doesn't cover the holes (?) on the sides at all, but it's definitely working.
     
Thread Status:
Not open for further replies.

Share This Page