Kanger Tank

Discussion in 'New Members Forum' started by Mateo the Great, Nov 15, 2013.

Thread Status:
Not open for further replies.
  1. Mateo the Great

    Mateo the Great Senior Member ECF Veteran

    On the Kanger Pro Tank II, I continue to get juice coming up and out of the mouth piece.

    Am I doing something wrong?

    On a standard Ego-like battery called the VaporZ.

    Please help!
  2. ZNinja

    ZNinja Senior Member Verified Member ECF Veteran

    Coil is flooding. Might try an additional flavor wick if you are running a thin juice.

    KYBLUE Senior Member Verified Member ECF Veteran

    Did you make sure the coil head was firmly tightened into the base? They are often loose when received from the factory.
  4. Jayviator

    Jayviator Full Member Verified Member

    If you pull the top off the atomizer head and just add a small flavor wick on top of what's already there (like half a strand of silica or a small piece of cotton), it will stop the flooding. Had the same issue when I first started with a protank.
  5. InTheShade

    InTheShade Vaping Master Verified Member ECF Veteran

    Supporting member
    Keeping your protank above 1/2 full will help too. There is a small chance you are getting the vacuum effect.

    To break it, flip it over and open the base, this will break the seal of the vacuum.
  6. oldbikeguy

    oldbikeguy ECF Guru Verified Member ECF Veteran

    If you over fill it that can happen also that white donut needs to be pushed all the way down it kind of snaps in place,some folks have removed them and caused that problem it needs to be in place thats the seal not packing
  7. RubyRoo

    RubyRoo Super Member ECF Veteran

    Be sure that you didn't accidentally pour juice down the center air-flow tube, and also be sure that your atomizer head is screwed down all the way into the base. If you are using a high PG juice, you might need to add some flavor wick as a few of the above posters mentioned. The teeny-tiniest strand of rolled cotton ball will work great.
Thread Status:
Not open for further replies.

Share This Page