1. SFATA power breakfast with California State Senator Joel Anderson

    Dear Guest, 

    SFATA are being hosted by California State Senator Joel Anderson this Weds for a "power breakfast". You can bring your input and ideas to him at his El Cajon district office between 9.30 and 10.30. If you're interested and can attend, please visit www.tinyurl.com/SFATApowerbreakfast
     to book a place. Thanks!

    Dismiss Notice

KTS firing button heating up quick.

Discussion in 'New Members Forum' started by xLionHeart1992x, Nov 28, 2013.

Thread Status:
Not open for further replies.
Image has been removed.
URL has been removed.
Email address has been removed.
Media has been removed.
  1. xLionHeart1992x

    xLionHeart1992x Full Member

    Nov 18, 2013
    I've had my KTS for awhile now, and it was working fine as normal. Recently though, my firing button has been heating up within 2 seconds before the whole mod heats up. It's gotten bad enough to where I've burnt myself a couple times on it. I use an IGO-W on it and nothing is wrong with my atomizer(it does it with other atomizers as well). I have tried filing my contacts down and cleaning the whole thing, and nothing has worked. I am now using a mod that I'm borrowing from a friend of mine. I want to find a solution for my problem here before the Inland Empire Vape Meet in riverside this Sunday. Anyone have suggestions?[​IMG]

    Vape It Forward (VIF)
  2. xLionHeart1992x

    xLionHeart1992x Full Member

    Nov 18, 2013
    Forget this thread, I sold this mod and got a Magneto instead.

    Vape It Forward (VIF)
  3. Margate69

    Margate69 Super Member Verified Member ECF Veteran

    Vape it forward? You handed off a pipe bomb that has a short.
  4. Lunger

    Lunger Senior Member ECF Veteran

    Aug 21, 2013
    South Florida
    I had this happen with my Ehpro Electric Angel clone. In my case it was one of the screws on the negative post of the IGO-W that had become slightly loose with heat. Sometimes your screws on the posts can loosen up a bit when the wire heats up so check these often if you feel heat on your button or if the resistance seems to be jumping around a bit. You can also try washing your entire mod. Use warm water and soap and be gentle with the contacts. Once everything is cleaned up, apply some noalox lube on the threading of the mod and a tiny dab on the firing pin/switch. This helps with conductivity. Theres a post here on ECF describing noalox: http://www.e-cigarette-forum.com/forum/cloud-9-vaping/170171-noalox-why-we-use-mechanical-mods.html

    Don;t know what your exact issue was but it could have been a short, a loose screw in the posts, dirty contacts or threading, oxidization, collapsed spring etc. Also forgot to mention it could have been your battery to. Make sure it can handle the amperage you;re pushing and makesure the battery is not damaged due to age or misuse. Check how much voltage it's retaining off the charger and how fast it's draining. Sometimes as batteries get old the best thing to do is just replace them.
  5. Ryedan

    Ryedan Registered Supplier - Offline ECF Veteran

    Mar 31, 2012
    Ontario, Canada
    This has never happened to mine, but it does happen to people. Here's a link to a tutorial on how to clean the contacts. What you've got is resistance somewhere that's causing heat.

    Let us know how it works out for you :thumb:
Thread Status:
Not open for further replies.

Share This Page