Might I ask a hardware question please?
Ask away , if I can't assist you , there's always someone in the ARMY that can , that's what this thread is for .
Might I ask a hardware question please?
all you need to do is ask
AHHH but you were Grasshopper , as I said the ARMY is always here to assist you !
Thank you
Actually, my question is multi part. I have a kayfun 3.1 clone, and a kayfun lite clone on the way. I am not sure if the lite clone is a regular lite or a plus model. If not, is the air flow control really needed, and if so, can it be modified to have some sort of afc?
LA on a dual coil setup it's half the resistance , in another words if your MVP says your resistance is 2.0 ohms there are two 4 ohm coils in your Nautilus , your best bet is to run in wattage or power mode instead of volts , in wattage mode your MVP checks resistance every time you fire and sets the voltage automatically , start at 7 watts and work up , the Aspires like to be pushed , 10 - 12 watts is where I ran mine , the heads lasted for months .
Did a clean-up/rearrange of the vape shelves yesterday afternoon and got rid of a ton of old junk. Everything ProTank, Vivi Nova and similar vintage is now in the garbage bin.
Juices in rotation on top shelf. Steepers in black toolbox on bottom shelf.
Sent from my iPhone using Tapatalk 2
So the 3.1 should be good to go, but the lite may or may not work out for me, depending on whether or not I like the draw. Got it, and thanks a bunch. Any suggestions for a newbie entering the world of vaping and rba?
I ordered the 3.1 from angelecigs, the lite I bought in the classies. Dont know the brands of either of them
Hrm. Seems the only thing I can find is that the kayfun lite is from fasttech
I've heard that some clones have problems with the juice channels being too small. How willi know if I have that problem?