Little chuck HV?

Discussion in 'Thag Built / The Chuck' started by moonbeamz, Jan 17, 2012.

Thread Status:
Not open for further replies.
  1. moonbeamz

    moonbeamz Full Member Verified Member

    Just wondering if there is a stronger voltage battery that will work in the little chuck to raise the voltage higher than 3.7?
    Thanks
     
  2. Hottody

    Hottody Moved On ECF Veteran

    Yes...I believe you can stack two smaller batteries for 6 volt vaping. Try with LR Boge cartos to get similar effect of high voltage vaping,
     
  3. jeffakamax

    jeffakamax Unregistered Supplier ECF Veteran

    The LITTLE CHUCK will only do 4.2 / 3.7 v. Highest mAh is the 18350.

    The CHUCK can do higher voltage.
     
  4. MastiffMike

    MastiffMike The Spotted Tongue! Verified Member ECF Veteran

    Supporting member
    The length of the Little Chuck won't allow for dual batteries (that's one of the benefits of the grown up Chuck!) but you can get a similar vape by using a lower resistance atty/carto. Without knowing what you're currently using I can't tell you what resistance to go to but they're readily available as low as 1.25 (and I've seen 0.9 ohm hand wound attys!).

    To give you an idea, at 3.7volts with a standard Boge 510 (2.3 ohm resistance) you're getting 5.95 watts. That same Boge at 5volts would be 10.87 watts. So to get a similar vape while staying with 3.7volts, you can go with a 1.5ohm atty/carto and have 9.13 watts or at 1.25ohms you'd be at 10.95 (almost EXACTLY what a standard 510 at 5 volts is!)

    It's very common for people to like their vape to be in the 7-10 watt range, and you can do it with the Little Chuck just fine as long as you get an atty/carto that's low resistance.
     
  5. bonniegirl

    bonniegirl Ultra Member Verified Member ECF Veteran

    Supporting member

    That dog knows his chit!

    Hi Mike!
     
Thread Status:
Not open for further replies.

Share This Page