Hi Fellow Vapers,
I made a new nautilus coil. I took the dual coil head and completely gutted the thing.
I then took a toothpick and twisted it in as far as I could into one of the empty holes where the
juice comes in and cut the tooth pick off up tite against the head with my wire cutters.
I then did the same thing with the opposite hole and cut off the tooth pick.
I took a small drill and drilled rite thru from one wick hole to the other.
I then made my coil by sliding a jewlers screwdriver thru the hole.
I made my wick and slid it thru and wet it good.
Used 32 guage with 5 wraps and it came out to 1.8 ohms.
Working ood no dry hits and no gurgling.
Had fun doing this nd just stumbled onto the tooth pick idea.
I made a new nautilus coil. I took the dual coil head and completely gutted the thing.
I then took a toothpick and twisted it in as far as I could into one of the empty holes where the
juice comes in and cut the tooth pick off up tite against the head with my wire cutters.
I then did the same thing with the opposite hole and cut off the tooth pick.
I took a small drill and drilled rite thru from one wick hole to the other.
I then made my coil by sliding a jewlers screwdriver thru the hole.
I made my wick and slid it thru and wet it good.
Used 32 guage with 5 wraps and it came out to 1.8 ohms.
Working ood no dry hits and no gurgling.
Had fun doing this nd just stumbled onto the tooth pick idea.