Micro coil above 1.5ohms please help

[thekidzac]

okay so, i need to know how to ensure my micro coil will stay above 1.5ohms as that is the lower threshold for my zmax v5. what is the easiest way to achieve this with minimal "trial and error" attempts. or should i just avoid a micro coil all together?

EDIT: this is going into a protank 2 so it'll have to fit without shorting out.... i've watched youtube videos to ensure its possible, but all the builds come out below my 1.5ohm requirement (at least that ive seen so far)

 

[Jonathan Tittle]

You can do a micro coil with 32g Kanthal on a 1/16" drill bit and it'll get you above 1.5, but anything lower is going to require quite a few wraps to get up there and is going to get really hot. I've tried 28g and always seem to have bad luck (i.e. the rubber grommet burns up).