Micro coil

Discussion in 'General Vaping Discussion' started by Eblyth00, Jul 15, 2013.

Thread Status:
Not open for further replies.
  1. Eblyth00

    Eblyth00 Senior Member ECF Veteran

    Could you use 34 gauge kanthal to make a micro coil. I know the ohms would be high but would it work on a 6volt device

    Sent from my GT-N7105 using Tapatalk 2
     
  2. jefsview

    jefsview Vaping Master ECF Veteran

  3. gotalotgoingon

    gotalotgoingon Ultra Member Verified Member ECF Veteran

    Yes you can use it. You ohms will be dependent on how many wraps, and the diameter of your coil. The more wraps you have, the higher your resistances will be and so forth.
     
Thread Status:
Not open for further replies.

Share This Page