My fix for the Nemesis button. And how to shorten the throw.

Discussion in 'APV Discussion' started by Three5Nines, Feb 22, 2014.

Thread Status:
Not open for further replies.
Image has been removed.
URL has been removed.
Email address has been removed.
Media has been removed.
  1. Three5Nines

    Three5Nines Full Member

    Joined:
    Nov 7, 2013
    Location:
    US
    [​IMG]

    You will need a mouth piece cover like what you get from the vapes shops to test their juices.

    [​IMG]

    Put the mouth piece on a 510 Dripping Atty, Carto, or on a gutted disposable like I 've done here.

    [​IMG]

    While applying downward force, roll the end on a smooth hard surface.

    [​IMG]

    We're rolling.

    [​IMG]

    We're rolling.

    [​IMG]

    And done.

    [​IMG]

    PERFECT!

    [​IMG]

    A normal Nemesis fire button. (Note the throw.)

    [​IMG]

    Take out the bottom pin/contact screw.

    [​IMG]

    Put the disk on the pin.

    [​IMG]

    Reassemble the button. (Note the throw.)
    The silicone disk acts and a spacer and a friction washer.
    The throw has been reduced to about half.
    You can finger tighten the pin, and it will not come lose.
    If you decide you want to go back you can. No permanent modifications to the Nemesis have been made.




    Forbear the utilization of voluminous expression when diminutive assertion will suffice.
     
  2. alternatifer

    alternatifer Senior Member ECF Veteran

    Joined:
    Jan 2, 2014
    Location:
    Jakarta
    Thank you,.I'll definitely try this
     
  3. Juiceinator

    Juiceinator Full Member

    Joined:
    Apr 11, 2013
    Location:
    New England
    Awesome. I have a magneto and the throw is ridiculous, its one of my two complaints. This looks like itll work on the magneto pin also and if it doesn't at least i can find a rubber piece that will fit it.
     
  4. azndrifter

    azndrifter Full Member

    Joined:
    Jul 25, 2013
    Location:
    Winnipeg, mb, can
    For me I just ended up using 3 magnets ever since I got rid of the spring my swich is so smooth if I'd like to adjust the switch i remove magnets or add more. 3 magnets I find is the best set up. But this is an innovative an inexpensive way to adjust the throw. good Job

    Sent from my SM-N900W8 using Tapatalk
     
  5. gpjoe

    gpjoe Super Member Verified Member ECF Veteran

    Joined:
    Oct 30, 2013
    Location:
    Motown
    Me too. I had to use three to keep it from firing with my heavier atomizers. The shortened throw was a bonus.
     
Thread Status:
Not open for further replies.

Share This Page