Need advice on Kayfun Mini V3

[ValevGK]

About K3 mini IMO is not better to vape on subohm type! It is not designed for this type in first, and after all it going be so hot after few inhale! It's can be use for TC but not over than 200 degrees celsius. Be aware of this! ;-)

Send via my Honor 4c using Tapatalk

 

[vapdivrr]

Hi Heisenberg
Glad to hear you got it sorted out, but don't stop trying to improve it. Try 24 guage SS with 4 tight wraps, 3 mm ID coil, wicked with Rayon, and lifted up off the airflow hole. It should provide you with about 0.25 ohms.

.25 on a km3 with 24g? Are you vaping this exact set up? Just curious if you are, at what wattages?

Sent from my SCH-I545 using Tapatalk

 

[Smoke_too_much]

No I don't have any K3 mini's.

 

[vapdivrr]

No I don't have any K3 mini's.

I maybe reading your post incorrectly, and if so, excuse me, but the kayfun mini v3 is not an rta for anything low. For one I doubt one could trap 24g under the screw heads and the tank itself is not rated to go much under .6 in ohms, preferably in the 1 to 1.4 ohms range. If one would use resistances under .2 ohms and use 24g, you really would have to watch the wattage, for anything over maybe 30 max would probably be to hot and may melt the insulator. It's a great tank, one of my favorites and I feel like I'm at the higher end of its limits by resistances at .7 and 25 watts with 26g, but under .2 ohms? Not really for this tank

Sent from my SCH-I545 using Tapatalk