Need help finding appropriate tube-mod for Genius2

[platzerj]

Dear community,

The next days I will finally receive a Genius2 RTA from German Stil Vapor and therefor I am in search of an appropriate fitting tube mod. The base of the rta is 23mm.

I am preferring high quality tubes instead of cheap ones. Important is a quite seamless transit between tube and rta.

Currently I am vaping on a kayfun v4 on a ProVari P3 at about 14-16 W on 1,5 ohms.
Therefore I am curious if a Procyon from ProVape that will deliever 50W would be enough powering up the rta even with a dual coil setup.

Currently friends told me the following mods:
Taifun Scarabaeus
Taifun Vireo Maxi
Both are mechanical

ProVape Procyon, as non-mechanical device.

Looking forward to your opinions,

Vape On

Yogi

 

[rice721]

There aren't alot of selections when it comes to regulated tube mods.

Provari and Dicodes springs to mind.

Dicodes Dani Extreme V2+ (22mm diameter all around), 2380 & 2380 telescopic (23 diameter top and base which tapers to a 22mm body). Altho they only fire up to 40W with a single battery setup however you can purchase extenders for dual battery setup and the mod will fire up to 80W.

Best bet would be to go mechanical as your have more selection. Just get batteries from reputable sellers and make sure the Amperage required is within the limits of your battery.

 

[platzerj]

Hey Rice,
Thx a lot for your thoughts.
Which mechanical mods should i consider to look on?

 

[rice721]

Hey Rice,
Thx a lot for your thoughts.
Which mechanical mods should i consider to look on?

Can't help you there as the only "mech-like" mod I have is the Atto Clone, perhaps ask it in the Mech mod subsection.

 

[Bad Ninja]

King knurled clone in brass.
23mm, solid brass, recessed button, reverse threaded lock ring, adjustable copper contacts. Accepts all 18xxx battery sizes.
Built like a wrench, hits like Conor McGregor.