Need RBA help!!!!

[Tom S]

Trying to work with the kangertech rba base, the ohm reading keeps showing .11ohms and it doesnt seem right. Feel like it should be around .66 or .5 ohms (they are the coils included with the rba bag). My battery is 3.7 volts . having to crank it up to 34 watts where it was just working awesome at 15 watts.

Why is the ohms reading so low??!!!

 

[sawlight]

Slow down, take a deep breath, then tell us what mod and rba you are using please.
I have the Dripbox and the coils that come with it are set up to be at .2 ohms. Singly they would be .4 ohms. So if that's what you are using, it's not that far off.
But without knowing what you are using, I'm just guessing at best!

 

[PaulBHC]

Is any part of the coil touching the bottom of the base, the top cap, the sides? Did you trim the legs close to the screws?

 

[Two_Bears]

Is any part of the coil touching the bottom of the base, the top cap, the sides? Did you trim the legs close to the screws?

I agree. Sounds like possibly a short og one of the screws is not making contact.

 

[Tom S]

Pretty sure the ends are clipped and nothings touching

 

[Tom S]

Whats an og?

 

[rice721]

Pretty sure he meant "or"

Take a pic of your coil installed on your rba deck.

Also what material are you using to build your coil?

 

[Tom S]

The one it came with like i said. It reads .11 even if i switch coils.

 

[Tom S]

The one it came with like i said. It reads .11 even if i switch coils.

 

[Tom S]

Found out if you unscrew the tank halfway, you can force it to redetect the ohms, but since i use it right handed displayed, the +/- to prompt for new atomizer is backwards if you looked at it sideways, so the + is on the right side. Occ coil is reading on first tank and RBA is reading on the second. Still not getting coil set in right for RBA on the second tank. Vape store dude said i had too much cotton in the coil first time i tried so no idea on how much should be in there