1. Take part in the #WeAreVapor campaign

    Dear Guest, 

    The  #WeAreVapor campaign has just launched and needs your help. This is a massive push to get vapers and vapor businesses visible, and make Congress aware of the Cole-Bishop amendment. It is being organised by the Vapor Technology Association. 

    Please take a minute of your time to take a look at the site to see how you can get involved. 

    Thanks!

    Dismiss Notice

NETs and EVODS = Bad :(

Discussion in 'Tanks, clearomizers and drop-in coils' started by RPGZealot, Feb 10, 2014.

Thread Status:
Not open for further replies.
Image has been removed.
URL has been removed.
Email address has been removed.
Media has been removed.
  1. RPGZealot

    RPGZealot Senior Member Verified Member ECF Veteran

    Oct 15, 2013
    CA, by way of NJ
    I don't know where else to put this, but I'm really only enjoying NETs and my EVOD (and MPT2s) are not handling it well. That is, I need to swap out coils 2-3 times a day to keep the flavor right, which isn't very cost effective.

    I'm currently using an MVP2.

    My question is: what can I (should I) be using to get the most mileage out of NETs?
     
  2. Topacka

    Topacka Super Member ECF Veteran

    Jan 8, 2014
    Seattle
    What's the pg/vg ratio?

    You could rebuild your heads w/ a micro coil and cotton so you don't have to buy new ones.

    A dripper would fix your problem too.
     
  3. Foodacris

    Foodacris Senior Member ECF Veteran

    May 11, 2013
    Evansville, Indiana
    You haven't even tasted an NET until you've dripped it
     
  4. RPGZealot

    RPGZealot Senior Member Verified Member ECF Veteran

    Oct 15, 2013
    CA, by way of NJ
    I've rewicked with cotton to no avail.

    How does one get started dripping? This bit I got from MBV was a nightmare. Terrifying.
     
  5. Topacka

    Topacka Super Member ECF Veteran

    Jan 8, 2014
    Seattle
    You could buy an rda like the mini smok rda, or the igo l or igo w on the cheap and try your hand at rebuilding, see how you like it. Those are all drippers.
     
  6. Foodacris

    Foodacris Senior Member ECF Veteran

    May 11, 2013
    Evansville, Indiana
    Try out either the Igo-L or Igo-W. Can't go wrong with either. All you need after that is the kanthal and cotton or whichever wick you choose. The simplicity is the beauty of it all.

    Also, I do recommend getting the air holes drilled out a little. It's not a must, but people do tend to like RDAs to be just a tad airier than most clearos or tanks. They don't need to be huge like you're trying to blow clouds or anything, but the stock air holes on the Igos are pretty darn tiny. Kidney Puncher will actually pre-drill them before they ship them out to you if you want.
     
  7. RPGZealot

    RPGZealot Senior Member Verified Member ECF Veteran

    Oct 15, 2013
    CA, by way of NJ
    Do either of you know of a beginners guide to RDAs?
     
  8. Topacka

    Topacka Super Member ECF Veteran

    Jan 8, 2014
    Seattle
    Don't know of any guides, but you should read the stickies in the rebuildable section, and watch a ton of videos on YouTube. Read up on battery safety, make sure you're familiar with ohms law. Might seem like more work than it's worth, but it's not.
     
  9. Foodacris

    Foodacris Senior Member ECF Veteran

    May 11, 2013
    Evansville, Indiana
  10. ScottP

    ScottP Ultra Member Verified Member ECF Veteran

    Apr 9, 2013
    Houston, TX
    What is a NET? Is it something like WTA?
     
  11. yellowrider

    yellowrider Super Member Verified Member ECF Veteran

    Dec 22, 2012
    MN
  12. Topacka

    Topacka Super Member ECF Veteran

    Jan 8, 2014
    Seattle
    Natural extraction tobacco. Full tobacco alkaloids, not just nic.

    Women's Tennis Association?
     
  13. ScottP

    ScottP Ultra Member Verified Member ECF Veteran

    Apr 9, 2013
    Houston, TX
    WTA = whole tobacco alkaloid. So it sounds basically the same. Thanks.
     
  14. RPGZealot

    RPGZealot Senior Member Verified Member ECF Veteran

    Oct 15, 2013
    CA, by way of NJ
    So, I ordered an IGO-L (as it looked pretty simple) to start with. We'll see how it goes. Thanks again!
     
Thread Status:
Not open for further replies.

Share This Page