Nhaler silencer

Discussion in 'Nhaler' started by MTFogger, Jan 16, 2014.

Thread Status:
Not open for further replies.
  1. MTFogger

    MTFogger Senior Member ECF Veteran

    Is the Nhaler silencer adjustment wheel suppose to be free flowing or click when turning it?
     
  2. Drewsworld

    Drewsworld Vaping Master ECF Veteran

    Free Flowing....Thanks
     
  3. MTFogger

    MTFogger Senior Member ECF Veteran

    Thanks. It would be nice and better if it was click-able to help keep it in place on the setting.
     
  4. MTFogger

    MTFogger Senior Member ECF Veteran

    How can you check to see if a silencer has a short in it?
     
  5. Drewsworld

    Drewsworld Vaping Master ECF Veteran

    Honestly not sure? It either works or it doesn't, as far as I know.
     
  6. exnihilo

    exnihilo Super Member Verified Member ECF Veteran

    I wish mine did either. It appears I got a bad and very crunchy potentiometer in mine. I've tried contacting them, but to no avail. Anyone know an easier method of contact for an exchange? I try the preferred channels first, i.e., their website. Who would I PM on here?

    Thanks!

    cg
     
  7. hittman

    hittman ECF Guru Verified Member ECF Veteran

    Supporting member
  8. Drewsworld

    Drewsworld Vaping Master ECF Veteran

    Yup that's it...I got back to him yesterday...Thanks Hitt!!!
     
  9. hittman

    hittman ECF Guru Verified Member ECF Veteran

    Supporting member
    No problem. I still try to read your forum whenever I can.
     
  10. exnihilo

    exnihilo Super Member Verified Member ECF Veteran

    Thanks folks! Sent it out Thursday, FedEx. It will be there Tuesday.

    cg
     
  11. exnihilo

    exnihilo Super Member Verified Member ECF Veteran

    Drew, you the man. Thank You!

    cg
     
  12. MTFogger

    MTFogger Senior Member ECF Veteran

    Ok guys heads up. Nhaler Silencer center post can be pushed in flat when installing it to the point that it will cause both negative and positives posts to touch and short out on both kamry and atm E-pioneer pipe heads. Center post are a tad bigger on most if not all pipe heads than standard 510 connections. Blew some pipe heads in the process of using them. Contacted Nhaler awhile back about them shorting out but all I got was it worked on their pipes when tested.

    Here is a fix: DO this at your own risk
    Made a rubber doughnut washer from a V2 cig condom same size as threaded side post (inside). Cut a small center hole in it. Alternative is find a very small thin flat rubber washer that will fit.
    Take a safety pin and work the center post outward (ever so gently). Pull out so the mushroom head just clears the top thread.
    Put on the washer.
    Push head back in.
    This will stop the center pin from going too far in.
    Caution pulling out the pin may cause damage or break internal wiring if pulled too far out.

    Maybe Drew can contact makers a suggest adding a fix.
     
  13. SubGothius

    SubGothius Full Member

    I just got a Silencer with chrome epipe package deal, loving it so far, turns out if you screw down the Silencer to a connector base that's at least as wide as the VV dial (as is the case with this pipe), it effectively locks the dial in place where you set it; to change the voltage, just loosen the connector slightly, twist the dial, and gently retighten.
     
Thread Status:
Not open for further replies.

Share This Page