Nuppin' O-ring question

[gpjoe]

Hi all. I know that the Nuppin' is very popular in Reoville, so I'll post this here:

Can someone please tell me the size of the O-rings for the Nuppin' cap and deck?

I'll admit that the info is probably already available but I cannot find it doing a search.

Thanks in advance

 

[Spydro]

1x10mm on the atty base, 1x11mm on the topcap/afc

 

[gpjoe]

You are the best - thank you.

 

[Raynman]

I'm thinking it's a 1x13 for the two orings on the atty.

 

[gpjoe]

It may be if you measure the OD. A 1 x 11mm O-ring has an 11mm ID and 13mm OD. I hope it's the 1 x 11 because I already ordered some. Not a huge deal as they only cost me a few bucks, but still inconvenient.

 

[Train2]

Here's a Nuppin Specs post from pDib, and it just says 1x10.
Not to further muddy things up...

 

[gpjoe]

Great

Well, I ordered a pile of 1 x 10mm and 1 x 11mm so I will soon find out.

 

[Spydro]

Train linked early specs on the Nuppin' V1. I quoted an update Peter added later when the V2's came out. The caps are interchangeable, so assume he changed to a better size for the base o-rings useable on both versions so the caps are not as tight to the base. Folks with Mech Woodvil's have pulled 510's loose when pulling Nuppin' top caps. Not sure if with both V1's and V2's though. So I quoted the newer specs.

pdib... "ADDIT: OH! when you're looking back at previous posts re: o-ring sizes. V2 atties were very specifically spec.ed and machined for 1x10mm on theattybase, and 1x11mm on the topcap/afc. You could still play with half sizes (like 1x11.5mm) for tighter or looser fit."

 

[Train2]

Good to know, I've got both!
Thanks Spydro!

 

[Papa_Lazarou]

Yep - pdib PM'd me with the same specs as Spydro quoted when I asked a while ago.

 

[gpjoe]

Yep - pdib PM'd me with the same specs as Spydro quoted when I asked a while ago.

OK, suddenly feeling better...