Just bought an ohm reader not too long ago, and whenever i build dual coil set ups it wont read anything in the sub ohm range.
for example, i build on the reader and when i put in the first coil it reads fine; i get 1ohm readings 1.2 readings but when i put the second coil in it will read 654 or 549 or somthing along those line. i do check the ohms on my multi meter tho and i do get proper readings from that.
now does anyone know why the ohm reader is reading like this? i am assuming that is reading a more accurate reading like instead of .54 ohms it will read as .548 ohms just with out the decimal. i just want to confirm this. can anyone add some insight? i couldn't locate a thread with similar issuse.
for example, i build on the reader and when i put in the first coil it reads fine; i get 1ohm readings 1.2 readings but when i put the second coil in it will read 654 or 549 or somthing along those line. i do check the ohms on my multi meter tho and i do get proper readings from that.
now does anyone know why the ohm reader is reading like this? i am assuming that is reading a more accurate reading like instead of .54 ohms it will read as .548 ohms just with out the decimal. i just want to confirm this. can anyone add some insight? i couldn't locate a thread with similar issuse.